Do yourself a favor and DO NOT weld the tabs to the tie rod directly. Get yourself a beefy tie rod clamp and weld the tabs to that so you have full adjustability and also do not jeopardize the integrity of the tie rod.
Here's a pic of mine. That's not getting damaged easily trust me. Is it possible? Sure but where would you even mount the skid? Under the tie rod welded to the axle tube?
Just got these delivered last night going to thrown them on tonight just wasnt sure about diff fluid capacity. These things look like they can hold more fluid than the stock covers so a little uneasy about putting the stock amount of fluid in there. Can anyone who runs these on their Rub give me...
Not the best pics but hopefully it gives you an idea on how much to cut. I basically cut the whole thing and jb welded where the two pieces of sheet metal pinched together. Sanded then painted
I forgot to add I made two adjustments to my driver side control arms at different times. The first adjustment was one full turn shorter. I was still experiencing pull but the steering was fine so I made the second adjustment of two full turns shorter for a total of three full turns. The other...
These were my numbers before I made my drivers side arm two full turns shorter so I'm assuming its a lot lower now. been meaning to get new alignment numbers
Just recently messed around with my control arm lengths at an attempt to combat some radial pull to the right. I made my driver side control arm about 3 turn shorter than my passenger. Shortly after my steering wheel does not return to center just sort of sticks or is jerky when it attempts to...
Whats going on guys got kind of a dumb question here but I failed jr high geometry so I need some help. After running my TF 2.5 coil lift for almost 3 years I am now noticing that my rear axle is offcenter about 3/4 of an inch towards the drivers side. So im looking to pull my drivers side tire...
Hey guys
Im assembling my inner and outer shafts from ten factory but ran into a little issue. After I took the caps off the joints I went to put them through the yokes and they basically didn't fit. I was only able to get 1 end of a joint through the yokes and put the caps back on but the other...