Search results

As close to an identical setup as you can get without just hitting copy and paste and this is beyond confusing to me.

Yeah when he told me this my brain just couldn’t reconcile it. Instant short circuit. But even if they were 5.38’s… the rpm still wouldn’t be that high. He’d have to be running something in the ball park of a 7.38 which isn’t possible or, programmed for a 28 tire but then his speedometer would...

I am the “buddy” mentioned. Mine is a 2014 5 speed auto and his is a 2015 5 speed auto so yeah, same trans.

Man that’s in my old area too. They’re a new type of special out that way.

Not internet related but… worthy of a post. My Wife just sent me this while I’m on a work trip. She spotted this in a parking lot and I’m dying. 🤣🤣🤣

I would get both and then sometimes it would be one or the other. Fun fact, if I manual shifted before 3200 rpm… it would never throw the code. 🤦🏼‍♂️

I’ve been fighting this same demon for so goddamn long. For me, it was the sensors on the back of the oil cooler. I couldn’t pinpoint which one so I replaced them both and did the oil cooler again since I was already there. I also noticed some wear on wiring loom for their plugs and, noticed...

Haha me too. She’s too cute to ignore.

Something something pimping other channels on this forum or something like that 🤣🤣🤣

It really is.

Was going through some travel pictures from last year and forgot I caught some epic sunrises during a fall trip to AUS.

The 8” ram is typically used for axles wider than 69.5”. If you’re running an XD60 WIDE (72.5”) then you ordered the wrong kit. PSC should swap it out for you drama free. However if you ordered their standard width then the 6.75 is what you should be using.

Definitely possible with these. They sit about half inch lower than the factory seat at its lowest setting. I ended up buying some urethane spacers and that got them pretty close to where I like.

Welcome from the Ogden area.

Agreed. It’s the one time of year I get to catch up with friends I wouldn’t normal get to see. Bummed to have missed it.

Odd comment. Last I checked everyone that joins these runs actually wants to be there.

Got the other side done and, did a little Home Depot riser mod and it cured the issue I had with them being too low and the lower cushion being too flat. Much happier now. I will say though that Corbeau really blew it with the brackets but, that’s another story.

Looks like a great time as usual. Looking forward to returning to action next year.

Pretty happy so far. Won’t be able to test drive them for a while but just sitting in them, I’m happy. They need risers though. They sit really low.

For the built in cock pump. Actually it’s for the inflatable lumbar support.