Close

Page 4 of 4 FirstFirst ... 234
Results 31 to 33 of 33
  1. #31
    Knows a Thing or Two Andy5160's Avatar
    Join Date
    May 2016
    Location
    New York
    Posts
    521
    Nice write up i have the same bumper and went with Maximus winch plate and the license plate bracket.There was no need to relocate the pump since i am ruing smittybilt x2o winch
    my license plate bracket however is different and is located below the fairlead. So far did not have any issues with clearance on the trail.

  2. #32
    Fresh Catch atomicdog's Avatar
    Join Date
    Feb 2015
    Location
    Nashville Tn
    Posts
    20
    Great thread OP! I installed mine today but I'll tell you I'm having a rough time getting the bottom inside nut on the driver side stud. Any advice on this would be great. Maybe i need to do more trimming on the factory vac pump mount and try it again. Hope to finish it up tomorrow. Thanks for any advice.


    Sent from my iPhone using WAYALIFE mobile app

  3. #33
    Fresh Catch CharlesC's Avatar
    Join Date
    Jan 2017
    Location
    NE Colorado
    Posts
    6
    Getting real close to pulling the trigger on this same plate, but not sure yet on winch brand and weight stamp. Thanks for the write up OP, I will be revisiting this very soon on my install🥃cheers!


    Sent from my iPad using WAYALIFE mobile app



Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •