Close

Page 10 of 10 FirstFirst ... 8910
Results 91 to 95 of 95
  1. #91
    Advertiser DynoMax Exhaust's Avatar
    Join Date
    Mar 2013
    Location
    MI
    Posts
    289

    Red face

    Still no update, we are backed up a bit on our production side.

    Quote Originally Posted by Buster3479 View Post
    Matt,

    Any update for the kit? Still trying to order one six months later, and still can't find one. Every Rausch trip seals off my exhaust pipe more and more, and I end up bending it open as far as possible when getting home. I'd really like to solve it with this kit. Is it available piecemeal with a pre-axle dump if I'm willing to toss the rebate chances out?
    This right here. A lot of gone this route and been happy.


    Quote Originally Posted by TomRalph View Post
    I used the parts listed in Eddie's review thread, you only need about 6" of pipe to connect the muffler and resonator.

    You will need to fab a hanger to use the evaporator skid bolts, otherwise you will have some banging.

  2. #92
    Hooked whispike's Avatar
    Join Date
    Oct 2011
    Location
    So Cal
    Posts
    200
    Quote Originally Posted by DynoMax Exhaust View Post
    OK the P/N that we use in this is the Ultra Flo Welded PN 17823 this is an offset/center. That gives you the ability to angle it up. The Super Turbo P/N 17219 is also an offset/center.




    Don't run the tip.






    See above
    I'm not sure if the PN's have changed but I can't find either one listed on the Dynomax website.

  3. #93
    Advertiser DynoMax Exhaust's Avatar
    Join Date
    Mar 2013
    Location
    MI
    Posts
    289
    http://www.dynomax.com/ultra-flotm-w...tered-699.html


    http://www.dynomax.com/super-turbo-o...tered-629.html






    Quote Originally Posted by whispike View Post
    I'm not sure if the PN's have changed but I can't find either one listed on the Dynomax website.

  4. #94
    Caught the Bug rob_p's Avatar
    Join Date
    Oct 2012
    Location
    Albany, NY
    Posts
    95
    Is there a QuietCrawler equivalent for the 3.8s? (2011 JKU)

  5. #95
    Advertiser DynoMax Exhaust's Avatar
    Join Date
    Mar 2013
    Location
    MI
    Posts
    289
    Not Really (ISH) , but it will work with a little fabbing.

    So all the part numbers would be the same but on the intermediate pipe (PN 52561) the hanger will be in the wrong location. That would have to be realigned with the hanger on the 3.8.

    http://www.dynomax.com/downloads/ins...nstRev0316.pdf



    Quote Originally Posted by rob_p View Post
    Is there a QuietCrawler equivalent for the 3.8s? (2011 JKU)



Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •