Ausjeep113
New member
Haven't done any on the carrier this week but did go out for a bit of a play last night thought I better post a pic up.
2011 JKU build thread
- Thread starter Ausjeep113
- Start date
Ausjeep113
New member
Got in and got a bit done today, still waiting on the latch to turn up and need to do the roto pax mounts and hi-lift mount.
Slowly getting there should have it nearly complete by the end of the week.
Ausjeep113
New member
So this just happened!!!
Ausjeep113
New member
Just knocked together a quick little trail table ready for Easter weekend run.
Ausjeep113
New member
New uni joints ready for the weekend [emoji106]
wschilawski
Member
Rigs looking great! I love the trail table - very simple looking. Have you tried it out yet? Anything you would have done differently? :beer:
Ausjeep113
New member
I'll let you know about the table after this weekends run but so far I'm super happy with it. [emoji108]
I'll post up some photos of the carrier in a few minutes, it's mounted but still needs the roto pax mounts and highlift mount put on.
I'll post up some photos of the carrier in a few minutes, it's mounted but still needs the roto pax mounts and highlift mount put on.
Armydog
New member
That looks like an awesome fabrication, can't wait to see it completed. Nice!
Ausjeep113
New member
So I forgot about the carrier photos the other day so I'll try and do that later but here are some photos from the weekend. Had a great time and only managed to break one flare. Pretty happy about that's as there was no body damage 
Ausjeep113
New member
Still not powder coated and needs the roto pax mounts but I'm moving to the other side of the country this week so it's going to be a while before I get setup and find a workshop where I can continue working on it.
Ausjeep113
New member
Not at all but I do get a slight noise out of the latch over big bumps, I'll address that when I get a chance [emoji106]
TrailRidden
New member
Nice fab work!
Ausjeep113
New member
Thanks TrailRidden, it's getting there but plenty more work to be done [emoji106]
Ausjeep113
New member
Still working away on the other side of the country but managed to sell the ARB bumper so now just need to get home and clean the front end up so the new one can go on.
Ausjeep113
New member
Nothing really exciting to update but reinstalled the plastic factory bumper to keep it road legal and removed the plastidip from the grille so it can be re-done. I'll also need to stick the J back on, anyone have any ideas on what the best glue to use is?
PSC Bumper should be here on Tuesday so I'm keen for that!!
Sent from my iPhone using WAYALIFE mobile app
Ausjeep113
New member
Just been giving the jeep an overall birthday, painting all the black bits again, giving her a polish, going to re dip the grille and just getting everything ready for the PSC bumper to go on tomorrow [emoji106]
Sent from my iPhone using WAYALIFE mobile app
Ausjeep113
New member
Finally the PSC brawler lite showed up so I wasted no time unboxing it and bolting it on. Need to make up some new brackets to mount the light bar and hopefully getting a warn high mount next week. Overall I'm really happy with the fit and quality of the poison spider bar and such a breeze to install [emoji108]
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app