Dubaibentzen's build of Iceberg

Dubaibentzen

Dubaibentzen

New member
ImageUploadedByWAYALIFE1462206094.746576.jpg
Front Dana 30 axle removed as it needs a bit of work. Both tires were like this / \ on the ground. C's will be straightened and a new set of balljoints put in.

But a Dana 30 is definitely not what I want to run with my Slabs and 37" tyres. So at the moment I'm thinking about "borrowing" Polar Bears Rubicon Dana 44 front and rear axle. As much as I want to throw on a ProRock 44 right now, it's a bit too much money.

So Polar Bear will probably get the leftovers and Iceberg will get all the good stuff.

Then later I could get an empty ProRock 44 axle for Iceberg and re-use the Rubicon internals.

Plus the Rubicon gear ratio is 4.10 which I think is doable for now and then I'll regear later to 5.13 to get a good acceleration in the desert.
 
Dubaibentzen

Dubaibentzen

New member
Monster Valve 2 kit just arrived from Powertank. Now I can install them on the slabs and start mounting the 37" STT PROs. I thought the version 2 of the Monster Valve looked at bit easier since I don't have to use a tapping tool.
 
Dubaibentzen

Dubaibentzen

New member
ImageUploadedByWAYALIFE1462679734.292044.jpg ImageUploadedByWAYALIFE1462679753.590058.jpg ImageUploadedByWAYALIFE1462679773.380805.jpg ImageUploadedByWAYALIFE1462679787.413527.jpg
Drilling for the Monster Valve 2 was a bit nerve wrecking. But it fits perfectly and now the air can get in and out fast.
 
Dubaibentzen

Dubaibentzen

New member
I'm really glad I got these valves. Deflates the 37" from 30 to 10 psi in 23 sec. Inflates back from 10 to 30 psi in 24 sec. Wow!
 
You must log in or register to reply here.
Top Bottom