OverlanderJK
Resident Smartass
Standard as in factory or standard as in on the middle of the carrier? Only one of those is possible.
EVO Tire Carrier Rotopax Gas Can Mount Solution
- Thread starter wayoflife
- Start date
Standard as in factory or standard as in on the middle of the carrier? Only one of those is possible.
SmokinV10
Caught the Bug
Standard as in the middle of the carrier.
Christarp
Member
I've heard this but have yet to see a picture of it. I've seen one where they stood up near the tire but AFAIK they were a one off custom bracket.
jkunlimitedsport_2010
New member
I am going to puill the trigger and do what Eddie did!
Eddie does it shake at all when driving?
JKsix
New member
I am also curious about this.
jkunlimitedsport_2010
New member
Eddie... Any more insight?
ak49
Member
This is the one that evo did for my jeep. It was done on a few other jeeps as well. Not sure if they are offering it or if they only do it in their shop.
rubicrawl
New member
Yes it does when you tighten the rotopax there's a little play but not bad and it doesn't rattle or anything I mounted 2 rotopax horizontally and I scraped the pax in Moab so yes you can scrap the pax or even tear them off if not careful
OverlanderJK
Resident Smartass
Didn't know you were a member here. Nice rig! :thumb:
Charlie Mike
New member
ak49 said:
Have any close up pictures of the bracket themselves? Without the rotopax?
ak49
Member
Thanks! I don't post that much on the forums. Debating on an engine swap now, but it seems like a lot of the bugs have not been worked out yet.
I don't have any on this computer. When I get back to my laptop I'll check to see if I have some....I'm overseas right now so I'm unable to go outside and take some.
Skumbag
New member
ak49
Member
If I remember correctly, 4 holes were drilled in the area of the top hole on the side brace and 4 bolts hold the bracket in place. If you look at the picture I posted and then a picture of a stock carrier, you can see that the stock carrier brace has 3 holes that are visible, where mine only has 2 (3rd hole is covered up by the bracket). You can see the 4 bolts on the sides of where the top hole is at on the stock carriers.
Crystaliner
Doesn't know shit about wheeling
I know this is a old thread......
Any new ideas??????
Any new ideas??????
ak49
Member
My jeep is at ORE right now if you want to see how mine are mounted.
Ddays
Hooked
I found these this past Summer
http://wayalife.com/showthread.php?37775-EVO-Tire-carrier-Rotopax-mounting-solution
Crystaliner
Doesn't know shit about wheeling
Please post a pic once you get your rig back. I'm sure Drew is getting tired of all my phone calls [emoji45]