highoctane
Caught the Bug
I think there was a piece of plastic on the corner of the foam back there. It is a very tight fit.
Sent from my iPhone using WAYALIFE mobile app
Rock Hard Jeep JK Wrangler 4-Door C-Pillar Brace Installation Write-Up
- Thread starter wayoflife
- Start date
I think there was a piece of plastic on the corner of the foam back there. It is a very tight fit.
Sent from my iPhone using WAYALIFE mobile app
Gadget
Caught the Bug
Finally getting started, knowing me it will probably take until tomorrow to finish. Got my question answered about the plastic, it's hard foam not squishy foam like I thought.
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
LOL!! Yeah, it's hard but that also makes it easier to cut :yup:
Gadget
Caught the Bug
Gadget
Caught the Bug
Should I put any anti seize on the 6 bolts for the clamps?
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
highoctane
Caught the Bug
I used a drop or two of cutting oil that I was using on the drill bits to drill the holes.
Sent from my iPhone using WAYALIFE mobile app
TrainWreck618
Caught the Bug
HardRock asks you to use WD40 on all of the bolts during installation
Sent from my iPhone using WAYALIFE mobile app
TrainWreck618
Caught the Bug
Gadget
Caught the Bug
Done finally, and at the rate I work it only took a day and a half:
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
highoctane
Caught the Bug
Is that the c pillar padding from Rockhard?
Gadget
Caught the Bug
Yes it is, I like it because it hides the imperfections in my cutting of the upper pad and wheel well carpet.
Sent from my iPad using WAYALIFE mobile app
Sent from my iPad using WAYALIFE mobile app
highoctane
Caught the Bug
I thought about getting it. I have the padding on the fwd t section and rear overhead bars. Didn't know they had a c pillar padding kit when I ordered the rest.
Sent from my iPhone using WAYALIFE mobile app
For those of you running our RH-1035 C-Pillar Brace Kit, what do you think about adding a MOLLE wrap option? It'd work with or without the RH-1035-P padding kit.
WJCO
Meme King
I'm not running that kit, but I think MOLLE wrap would be an awesome idea. :thumb: I think a lot of guys would run that.
Gadget
Caught the Bug
highoctane
Caught the Bug
LasVegasJK
New member
highoctane
Caught the Bug
Yeah I think the c pillar Molle would be sweet. It's close to the door, so good place to mount something like a fire extinguisher, first air kit, etc.
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app