GraniteCrystal
New member
Getting them all assembled. It'll definitely be two trips home. I'm not mounting them on Jeep till after C gussets are done this week. Starting them out at 30 psi (?).
GraniteCrystal build thread
- Thread starter GraniteCrystal
- Start date
GraniteCrystal
New member
Fun fact: not all balancing systems are created equal and DT will have different ones. I just asked the guy doing mine which one was best and he definitely knew which machine we should use. Not sure I would've ended up on that one if I hadn't asked though so may be worth bringing up the next time you're at DT.
GraniteCrystal
New member
I'm liking what I'm seeing!
Mike_JK_Houston_711
New member
SWEET! I would go lower in PSI on your 37"s, maybe around 26-28, but do the chalk test to be sure. Goddam, those tires are sexy. I CANNOT wait to get them in 40" at some point!
GraniteCrystal
New member
Got all 5 back home.
Time for LoD Destroyer bumper and tire carrier install! Picked up a few necessary items I didn't have but will need: bearing grease, 1.5" socket, 1/2" drill bit.
Time for LoD Destroyer bumper and tire carrier install! Picked up a few necessary items I didn't have but will need: bearing grease, 1.5" socket, 1/2" drill bit.
GraniteCrystal
New member
Unpacked the new bumper yesterday. Looks great. Packaging is intense.
Closeup up powdercoat:
One little nick on the powdercoat, otherwise it looks great:
Closeup up powdercoat:
One little nick on the powdercoat, otherwise it looks great:
GraniteCrystal
New member
Rear bumper removed. Goes extra fast with some help 
GraniteCrystal
New member
Holes drilled. Pain to do but not terrible. Mostly I suck at drilling 1/2" holes.
PROJKUR
New member
GraniteCrystal
New member
Got the stock carrier off.
Anybody want one? I'd like to get a little $ for it. Already has a nice custom 3rd light relocation job on it (one of the mods I did earlier in this thread).
Anybody want one? I'd like to get a little $ for it. Already has a nice custom 3rd light relocation job on it (one of the mods I did earlier in this thread).
GraniteCrystal
New member
Got bumper loosely on. Time to align it and tighten bolts.
Got to keep the frame clean!
Got to keep the frame clean!
JeepJeep75
New member
Looking good dude! Perfect time to dump some used oil in the frame! [emoji6]
GraniteCrystal
New member
Troubleshooting fit and instructions issues on another thread, starting here:
http://wayalife.com/showthread.php?p=851310
http://wayalife.com/showthread.php?p=851310
GraniteCrystal
New member
Bumper is on and tightened down!
Rubicon310
New member
What is your gap measurement on each side? Are you at 1/2 in or closer to 3/4 inch?
Sent from my iPhone using WAYALIFE mobile app
Sent from my iPhone using WAYALIFE mobile app
GraniteCrystal
New member
From the absolute tip of the bumper, I'm at 5/8". And I'm on a stubby, not full width.
GraniteCrystal
New member
Face plate on
