Headlight Aiming After Lift

[kevman65]

So, 2020 JT Rubicon. Sitting stock except for 35's, which I never adjusted the headlights for.

When I install the 3" lift, should I take top of light cutoff to where it is now, or a little lower to compensate fro the different angle?

Back when I was a "kid", I truly didn't give a damn. Now that I'm an "old fart" I want to piss off the fewest amount of people I can.


OH, factory LED headlights.

 

[wayoflife]

Park your Jeep 25' out from a wall, mark 3' up from the ground and set your beams to that point.

 

[kevman65]

Thank you sir!

 

[WJCO]

Park your Jeep 25' out from a wall, mark 3' up from the ground and set your beams to that point.

That's exactly what we did. So easy. And the adjustment screws are easy to get to.

 

[bobfriesenhahn]

It seems that this requires level ground and a wall 25' away. Not aways easy to find that combination.

 

[CalSgt]

It seems that this requires level ground and a wall 25' away. Not aways easy to find that combination.

I used the side of a supermarket late at night

 

[kevman65]

I used the side of a supermarket late at night

There's a commercial park not far from me, curb for parking slots is 25' from the side of the building.

It slopes a little left to right on a vehicle, but front to back is level.

 

[GP NOIR]

It seems that this requires level ground and a wall 25' away. Not aways easy to find that combination.

Make you initial adjustment, go drive the Jeep, go back to the wall and fine tune as needed. Do that a time or two and you'll be there.