I'm doing brake bleeding now
- Thread starter tkkim
- Start date
Paisano
New member
Yes the fluid will come out as long as he's pushing the pedal and you have it open. Be sure to close it before pedal goes to the floor. Make sure you don't run the master dry.
You may not see a bubble. You only need to push enough fluid through to replace the line with new fluid.
You may not see a bubble. You only need to push enough fluid through to replace the line with new fluid.
Last edited:
What do you mean 'master dry'?
Paisano
New member
Keep checking the master cylinder to make sure you don't run it low on brake fluid.
jeeeep
Hooked
this is a good write-up, even if you don't have this same bottles, the process is the same.
I use an well cleaned water bottle with just a little brake fluid already in it so I can see the air bubbles.
always start with the brake furthest from the master cylinder
http://wayalife.com/showthread.php?4335-MAINTENANCE-Bleeding-the-Brakes-on-a-Jeep-JK-Wrangler
I use an well cleaned water bottle with just a little brake fluid already in it so I can see the air bubbles.
always start with the brake furthest from the master cylinder
http://wayalife.com/showthread.php?4335-MAINTENANCE-Bleeding-the-Brakes-on-a-Jeep-JK-Wrangler
I just finished my brake job.. And the pedal is not as firm as before...
Shouldn't be firmer than before??
Do i have to get some time to be firmed?
if the pedal is soft, it means there is probably air in the line still. you should continue to bleed them to ensure that all of the air is out of the line. just make sure there is the proper level of fluid in the res. before you continue.