ProSteer/Reid Knuckle HELP!

I'm in the process of rebuilding my 08 JKU and wrapping up my front 44 build. I've replaced my ball joints with ProSteer's and installing my new Reid Knuckles. I torqued the castle nuts down in sequence as instructed and to the ft lb's instructed. And I still have a gap between the top of the top part of the knuckle and the bottom of the top ball joint. I seated the ball joints all the way too. :clap2: The bottom ones look fine. Should I be worried? Help!

That's the way my pro-steers sit. The factory ball joints have a rubber gasket that hides the space. That's why you don't see it with the factory ball joints.


WAYALIFE APP

Good to know! I saw a picture on their page and wondered if it was just that gap where a sleeve would be.. Thanks!

I did the same thing when input mine on. I was like wtf? Then I found some pics




WAYALIFE APP

I had left a message at Dynatrac early this morning. They got back to me and informed me the same.. It's normal and ok. I had done the same with Reid. Passed emails with pictures back and forth and felt better after words too. Thanks for the help!!