Drag link flip kit
- Thread starter Devallee
- Start date
kaptkrappy
New member
The arrows are pointing at the ends of the U-bolt. It goes around the axle tube at the end of the bracket.
I hope that helps
.
I hope that helps
.
Devallee
New member
So it goes nut, washer, nut? I guess what I'm trying to figure out is how to use those other two nuts that aren't on the u-bolt. Or maybe, how to use the two nuts that ARE on the u-bolt?
kaptkrappy
New member
The U-bolt should just have a washer and then a nut on each end.
You might have just gotten a extra couple of nuts in your hardware bag. (happens all the time)
.
You might have just gotten a extra couple of nuts in your hardware bag. (happens all the time)
.
Devallee
New member
Ok perfect thank you sir
BBrown626
New member
Throw out the standard nuts that are on there and use the self-locking nuts.
piginajeep
The Original Smartass
exactly, the U bolts just come with these when the hardware is purchased. Toss them in your tool box. Install the stovers
Last edited:
The nuts that cap it off are stovers. They shouldn't go anywhere.
EDIT: Am I wrong on this?
piginajeep
The Original Smartass
You are correct, the stovers come in the hardware pack. The Ubolts come with regular non locking nuts. Rather than open up every hardware bag EVO MFG just leaves them on.
no i do not believe that is normal. :naw:
Roger that - Carry on
In installing mine recently, I noticed that the u bolts had a larger radius than my axle therefore I would have to drill out the holes in the bracket. I just went and got a smaller radius u bolt. Worked perfect. Got them at my local bolt and nut supply store.
Good To Hear!!! :clap2:
jesse3638
Hooked
It seems you got it figured out. But if ur track bar was "too long" you probably had to adjust the axle towards the passanger side of the jeep.