jeepsterchris
Member
OK...so I'm sitting on the couch googling (don't tell my wife) and I cant find anyone who has attempted what I am thinking about. Probably some sort of warning sign right there.
I have an ARB rear bumper, and it has the cutouts for hi-lift jacks with the nifty rubber plugs in them. I was thinking of mounting a flush-mount LED spot in each hole, but I'm curious if anyone here had seen, heard or attempted to do so. The hole is 2 1/8" with and 2 3/4" tall. I talked to Sam over at Inspired Engineering (when I ordered my LED rock lights that I probably don't really need) and their flush mount lights need a 3x3" hole.
SOOOOOO...here's the next question. Is anyone running flush mount lights that would fith the smaller hole? and if so, what kind are they?
Here's a picture of the hole. I plan to drill and tap holes and run machine screws to fasten it on. Oh...and its a good 3-4 inches deep before it would run into any protruding mounting hardware.
Any advice, ideas and pictures are welcome!
Thanks,
I have an ARB rear bumper, and it has the cutouts for hi-lift jacks with the nifty rubber plugs in them. I was thinking of mounting a flush-mount LED spot in each hole, but I'm curious if anyone here had seen, heard or attempted to do so. The hole is 2 1/8" with and 2 3/4" tall. I talked to Sam over at Inspired Engineering (when I ordered my LED rock lights that I probably don't really need) and their flush mount lights need a 3x3" hole.
SOOOOOO...here's the next question. Is anyone running flush mount lights that would fith the smaller hole? and if so, what kind are they?
Here's a picture of the hole. I plan to drill and tap holes and run machine screws to fasten it on. Oh...and its a good 3-4 inches deep before it would run into any protruding mounting hardware.
Any advice, ideas and pictures are welcome!
Thanks,