Need Help with Rear Adams Shaft Install !!!

I am in the middle of my lift and drive shaft installation and have found the instructions on Adam's site suck! (They are actually okay, but they don't show my parts, that they shipped or what I have on my Jeep!)

Anyway, I have a question for those that have installed one of their rear shafts. (I have a 13' JKUR, manual) I am installing 1350 jointed shafts, but I think the 1310s are mostly the same.....

What do you do with the O-Ring on the T-case side for the rear? It was reused on the front, but the rear flange piece doesn't have machining to allow for the O-Ring to be installed. Any help is greatly appreciated (As I mentioned... In the middle of install)
 
Top Bottom