Coast 1310 install
- Thread starter Sugarbear
- Start date
cozdude
Guy with a Red 2-Door
eddies write up should answer most of your questions.
http://project-jk.com/jeep-jk-write...-front-1310-drive-shaft-installation-write-up
also make sure you install adjustable control arms to make sure your caster is set properly. here is the link on how to properly set it
http://project-jk.com/jeep-jk-write-ups/basic-do-it-yourself-jeep-jk-wrangler-front-end-alignment
jeeeep
Hooked
I called Coast and asked them when I installed mine, as long as you don't separate the DS at the spline, the yoke doesn't have any marks and just bolt it up.
Sugarbear
New member
Forgive me but I don't quite understand this can u explain more??
OverlanderJK
Resident Smartass
10frank9
Web Wheeler
Ahem... Photo cred... Ahem!
Sugarbear
New member
So if I don't split it like this I can just bolt it in and now worry bout it?
OverlanderJK
Resident Smartass
Yes just bolt it up. If you split it after it's on you should be fine as well. That is mine in the picture.
Sugarbear
New member
May I ask the reason for splitting it ?
OverlanderJK
Resident Smartass
I didn't do it on purpose lol. No lower control arms, wheels/tires and shocks allowed a lot of droop and it came apart. Was working on the rear axle when it happened.
Sugarbear
New member
Was it a pain to get right again ? Or did u just put it back together and it was ok
OverlanderJK
Resident Smartass
Just put it back together. It just slides right in. (That's what she said)