Tail light wiring help

Okay so today I installed the EVO rear corner armor. All in all it went pretty good, only real problem is the wiring on the tail lights. Currently the turn signals work but nothing else. Got the standard Maxxis lights with the 3 wire harness. In the OEM harness I have the following wire colors. Driver side: Grey, Red, Green, and black. Passenger side: Grey, Purple, Yellow, and Black. Does anybody know off hand which wire connects to which. I've tries about every combination but still a no go. Thanks in advance for any help.

I think off hand, Let me check. I put it in my build thread. You have load resistors?
Not sure if this will help anybody, but the wiring goes
White w/purple= running
White w/green= back up lights
White w/yellow= brake and turn.
Black= ground.
Or so at least I hope.lol.

And your lights 3 wires are white is ground, black is running and red is brake.

Thank you. I do have something mixed up then. Always figure black is ground. And yes the new harness has the resistor built it. I'll give that a shot in the morning.