Marson setting for nutserts? PSC rear flares?

tlminh

New member
So I just got the PSC rear fender flares, about to install the nutserts

I got the Marson 325-rn tool, and according to the instructions, I need to set the stroke to the thickness of the sheet metal

BUT the sheet metal is about 1/8 thick. If I use this setting, it will barely make a bend in the rivet

What do you guys recommend for the stroke setting on this tool?

I tried calling PCS and their response? "read the instructions that came with the tool." Gee thanks
 

Slappy32

New member
Use the little hook measuring guide that came with the tool to measure the depth and set the depth that way. Make sure you extend the stud on the tool to use all the threads on the nutsert.
 
Top Bottom