Condensation/foggy Head light

Had the JKU for a little over a month and noticed that the drivers side headlight had a build up of water/condensation in it...
I removed the housing got the water out and let it sit off the Jeep for about an hour before I re-installed it..:thumb::thumb:
NOW.. 3 days later... its fogging up/condensation build up again!!.:doh::doh:
I am going to up grade to TL LED soon, but until I do I would like to get the water out and keep it out...:doh:
ANY IDEAS? SUGGESTIONS???
It will be a couple weeks before I can get the TL LEDS.....:clap2:



(I joined a club.... The I'm broke, but have a bad-ass JEEP club):rock::rock::rock:

You are getting moisture in so I would recommend running a bead of silicone around the outer perimeter of the headlight. Also check to make sure the bulb is in tight and not cocked to one side.

R/
Will

Might also help to take the housing and try to figure out WHERE the water is entering from (look for pin holes, cracks, imperfections) so you have a good idea of where to place the sealant.

Sent from my SCH-I545 using WAYALIFE mobile app