Couple of dis-assembly questions.

2013 JKRU

Trying to run a video cable to the rear license plate camera. Plastic scree in the image below just spins:



Also, there are two screws the attach the rear inside panels to the floor. Do I just remove them an pull apart? Leery about forcing it. Running a CB antenna cable.

Thanks ... Ken

I couldn't get those pillar screws out so I just used a hanger and some tape to pull the cable through. The screws would just spin, even when I applied slight pressure...

The grommets on the floor can just be pulled up. You can used a trim remover tool or just anything strong with a flat edge. Pry them up and yank them out. Then when finished, just put them back in. :thumbup:

Sent from my SCH-I545 using WAYALIFE mobile app

Use a flat head and hold the outer washer from spinning with the inner phillips screw and it will come right out. Took me forever to figure it out!

Thanks guys!