EVO Auto Tranny Skid Install Question

Saharaunlmtd

Caught the Bug

• Apr 11, 2015

• #1

I'm going to do this install tomorrow and I've read through the Project-JK installation instructions and I can't figure something out. Why do u jack the transfer case up if the skid mounts on the stud? Any insight would be appreciated.

 

ERAUGrad04

Caught the Bug

• Apr 11, 2015

• #2

Pretty sure the reason is to give you enough room to maneuver the skid into place between the case and the exhaust crossover. It's pretty tight and without jacking up the case, I'm sure sure you could slip in the skid.

 

anviljk

Member

• Apr 11, 2015

• #3

Just for room. did mine a few months ago. Just go up enough to make room.

 

Panda

New member

• Apr 11, 2015

• #4

ERAUGrad04 said:

Pretty sure the reason is to give you enough room to maneuver the skid into place between the case and the exhaust crossover. It's pretty tight and without jacking up the case, I'm sure sure you could slip in the skid.

Click to expand...

This ^^^ :yup:

 

Saharaunlmtd

Caught the Bug

• Apr 11, 2015

• #5

Ok, thanks.