1 Inch PA Body Lift Question

Land Guru 1

New member
Installed a 1 Inch PA Body Lift - got a question

I installed a 1 inch Performance Accessories BL on my 13 JKU (already has the 2.5 suspension lift). When installing the blocks, I did not disconnect the steering shaft at the coupler because I read thru a few installation threads that it was not really needed - even thought PA instructions said I should. Well the install went well and I was done in about an hour and a half, but I noticed that where the steering shaft goes into the firewall that there is grease that looks like it oozed out somehow. Steering seems fine, but I want to be sure that I don't have to worry about the shaft somehow disconnecting. Anyone with experience with this care to comment please?
Thanks,
Don
 
Last edited:
Top Bottom