I installed an new rear drive shaft today. At ride height, the splines are showing. Is that normal?
I just spoke to a guy at J.E. Reel...He said the splines should not be showing. We agreed the problem is most likely caused by my wheelbase being longer than factory. My options are: have a custom drive shaft made or adjust the control arms to shorten the wheelbase...
I just spoke to a guy at J.E. Reel...He said the splines should not be showing. We agreed the problem is most likely caused by my wheelbase being longer than factory. My options are: have a custom drive shaft made or adjust the control arms to shorten the wheelbase...
I just spoke to a guy at J.E. Reel...He said the splines should not be showing. We agreed the problem is most likely caused by my wheelbase being longer than factory. My options are: have a custom drive shaft made or adjust the control arms to shorten the wheelbase...
I just measured. I'm 3/4 of an inch over the factory wheelbase. I didn't stretch it on purpose...it's my first lift kit install. That's my only excuse lol.
LOL!! Yeah, that's WAY TOO LONG even if you have 4" of lift. I would shorten your lower arms to something more reasonable like 1/8" longer than stock and then adjust your uppers as needed to set your pinion angle.