Evo C Gussett install problem

JK2DR

New member

• Sep 26, 2015

• #1

I have my front end torn apart and trying to install the evo c gussetts but ran into an issue. The lowers went on perfect, but the top doesn't want to fit. When I like the front side up, the back side has a pretty good size gap in between the gussetts and the c.
Tried uploading a picture, but its kind of hard to tell the gap. Can anybody help me out?!

 

Attachments

• 
  1443246513851.jpg

  63.9 KB · Views: 274

OverlanderJK

Resident Smartass

• Sep 26, 2015

• #2

Center it and weld it. It's fine.

 

JK2DR

New member

• Sep 26, 2015

• #3

OverlanderJK said:

Center it and weld it. It's fine.

Click to expand...

Its that easy? Shit I wish I made this post an hour ago

 

2013rubirick

Hooked

• Sep 26, 2015

• #4

JK2DR said:

Its that easy? Shit I wish I made this post an hour ago

Click to expand...

Yes it's that easy. Burn those things on there and be done. Just get them as even as possible and weld them up.

 

Strike Force Zebra

-

• Sep 26, 2015

• #5

Slow burn is your friend...... Or replace the ball joints

 

jeeeep

Hooked

• Sep 26, 2015

• #6

if you're OCD about the gap, just lay them on their side and tap them with a BFH, that's what I did ..otherwise what's been said...

 

JK2DR

New member

• Sep 26, 2015

• #7

Aspenkid said:

Slow burn is your friend...... Or replace the ball joints

Click to expand...

Yeah I'm replacing the ball joints at the same time

 

Pyro1415

New member

• Sep 30, 2015

• #8

jeeeep said:

if you're OCD about the gap, just lay them on their side and tap them with a BFH, that's what I did ..otherwise what's been said...

Click to expand...

This tack it and beat it.

or
Mig: decrease amps by a few and do a slow build up there.
Stick: Decrease amps by ten or switch to a 6013 and do a root pass right there to fill the gap.