rock hard 4x4 licence plate and 3rd brake light install

canadianjku

New member
Just picked up the rock hard licence plate spare tire relocation kit and their 3rd brake light/licence plate light. Just wondering if anybody has installed this and has some advice? Haven't been able to find a good write up and a bit confused about which wires to tap into. It mentions running it to the passenger side taillight instead of the original 3rd brake light for some reason
 

WJCO

Meme King
Just picked up the rock hard licence plate spare tire relocation kit and their 3rd brake light/licence plate light. Just wondering if anybody has installed this and has some advice? Haven't been able to find a good write up and a bit confused about which wires to tap into. It mentions running it to the passenger side taillight instead of the original 3rd brake light for some reason

This is the only write up I found: http://www.jeepsontrails.com/parts-...d-4x4-parts-license-plate-relocation-bracket/

This guy says it's a white wire with a gray stripe. I would verify power myself with a test light though. Also, if it doesn't work the first time, try flipping the LED wires, most LEDs only work with current in one direction. Your instructions should go over this.
 

canadianjku

New member
Thats great thanks. Should be able to figure it out now.

Just realized I need to take the rear bumper off to get access to the two lower screws holding the licence plate on. Bit more inconvient than expected

This is the only write up I found: http://www.jeepsontrails.com/parts-...d-4x4-parts-license-plate-relocation-bracket/

This guy says it's a white wire with a gray stripe. I would verify power myself with a test light though. Also, if it doesn't work the first time, try flipping the LED wires, most LEDs only work with current in one direction. Your instructions should go over this.
 
Top Bottom