Krystianjk
New member
How much would a conversion like this cost? Just the back. 
Rear panel conversion
- Thread starter Krystianjk
- Start date
jeeeep
Hooked
the one's in the photo are Poison Spyder crusher corners, EVO makes the corner rockskins
PS http://shop.poisonspyder.com/JK-4-Dr-Crusher-Corners-OEM-Taillights-p/18-05-022.htm
Evo http://www.offroadevolution.com/store/proddetail.php?prod=EVO-Rear-RockSkin-Corners
they make them for 2drs as well, so yoru cost is what they sell for + paint and install unless you do that part yourself
PS http://shop.poisonspyder.com/JK-4-Dr-Crusher-Corners-OEM-Taillights-p/18-05-022.htm
Evo http://www.offroadevolution.com/store/proddetail.php?prod=EVO-Rear-RockSkin-Corners
they make them for 2drs as well, so yoru cost is what they sell for + paint and install unless you do that part yourself
OverlanderJK
Resident Smartass
A conversion like what? Those are poison spider corners that had a piece welded on to them to make them like that.
Ore sells them as outlaw corners or builders corners and they are like $400.
Ore sells them as outlaw corners or builders corners and they are like $400.
Krystianjk
New member
highoctane
Caught the Bug
I've heard that poison spyder will custom make you a set of the corners in the 1st post for a larger cost. I still don't like them because they are only 1/8" instead of 3/16" like the Evo corners.
OverlanderJK
Resident Smartass
It's 1/16th difference. Not going to make a difference. That's like two pieces of paper.
Krystianjk
New member
highoctane
Caught the Bug
It's not much, but it is 33% thicker.
jeeeep
Hooked
just put one of their stickers on there, I wouldn't want an actual cut out or you'll need to seal it to keep water out