Hello Jeepers
i need to know some information from experts here
for non extreme off roader my dana 30 Holds some abuse after c gussets and truss kit but keeps blowing internal ring and pinion or spider gears if i push too hard with 37'' tires
what i look forward is i need to buy a better front axle and i am looking for dana 44 front axle thats why i have some questions
1- will it fit my JKU 2010 unlimited sport with no modifications? same OEM mounts?
2- as the ring and pinion and shafts are bigger & better and case have diff lock i am interested if i can run the locker by applying 12 volt to the coil and leave the locker sensor alone
3- will it hold 5.13 ratio because i run 5.13 on my 2010 front dana 30 with small crown and pinion and 5.13 on the rear dana 44
4- will the shafts be same for knuckle and fit other dana 30 components just like wheel bearings i mean is it 30 spline or 27 or the outers are same for rubicon shafts and non rubicon are same on the bearing side?
5- any other tips
thanks in advance.
i need to know some information from experts here
for non extreme off roader my dana 30 Holds some abuse after c gussets and truss kit but keeps blowing internal ring and pinion or spider gears if i push too hard with 37'' tires
what i look forward is i need to buy a better front axle and i am looking for dana 44 front axle thats why i have some questions
1- will it fit my JKU 2010 unlimited sport with no modifications? same OEM mounts?
2- as the ring and pinion and shafts are bigger & better and case have diff lock i am interested if i can run the locker by applying 12 volt to the coil and leave the locker sensor alone
3- will it hold 5.13 ratio because i run 5.13 on my 2010 front dana 30 with small crown and pinion and 5.13 on the rear dana 44
4- will the shafts be same for knuckle and fit other dana 30 components just like wheel bearings i mean is it 30 spline or 27 or the outers are same for rubicon shafts and non rubicon are same on the bearing side?
5- any other tips
thanks in advance.