Remove front jk quarter panel

BenJKWrangler15

BenJKWrangler15

New member
Using the research bar, I found little information about it. Can't quite find what I'm looking for.

It this guy right here that I want to know how to remove :

ImageUploadedByWAYALIFE1470197432.187780.jpg

Found this on another thread here on WAL from two months ago, started by RyangilJKU :

kpig said:
The front fender sheetmetal can be unbolted. Assuming you have already removed the fender flare and liner, there are several 10mm bolts that hold the fender to the core support and body tub. Starting from the front, there is one bolt under the fender behind the turn signal. Then there are several at the top of the fender, under the hood, that holds the fender to the core support. Unbolt the cowl and windshield bracket. Under the cowl are 2 more 10mm bolts. Under the front door, there are 2 bolts holding the bottom of the fender to the body tub. Inside the door jamb there are 2 more bolts holding the fender to the tub. On the passenger side, you will need to unplug the antenna from the mount. Good luck.
Click to expand...

IMO, it's a good start, but not as complete as I'd like it to be. So there's what, 12 to 15 bolts total? More? Anyone ever removed those to replace them? Need more intel :)

Thanks!
 
caminton

caminton

New member
Look up the rugged ridge modular snorkel install. It shows you how to take off the quarter panel. There's a video of it I believe.
 
You must log in or register to reply here.
Top Bottom