Evo lever question

Blazindevl

LOSER

• Aug 13, 2016

• #1

I'm going through and retourqueing all the bolts underneath the jeep and I just wanted to double check what the upper and lower rear control arms are supposed to be torqued to on the evo lever setup. Also the shocks as well, thanks.

 

Benito

Caught the Bug

• Aug 13, 2016

• #2

I think it will all be dependent on the type of hardware and grade. There are plenty of charts online. Disclaimer: I don't have that setup and am only assuming that is what would determine the torque specs

 

uberc4

New member

• Aug 13, 2016

• #3

I asked the same question when my lever was installed. Check the grade 8 torque specs online.

 

Blazindevl

LOSER

• Aug 13, 2016

• #4

Well the project jk torque guide says 125 ft lbs for the rear upper and lower control arms... I can't imagine the evo lever would be different but I just wanted to make sure