TormentedCrawler
New member
Hi all. Has anyone ever ran this combo. Recently purchased the rear bumper fascia and called offroad evolution. They mention it slips over the AntiRock bracket but I don't see how the physically possible.
Jeep jk Evo rear bumper fascia + rear Currie AntiRock swaybar
- Thread starter TormentedCrawler
- Start date
NevadaZielmeister
Caught the Bug
Here is what my setup looks like:
But it is not flush because I believe that ORE did this to make room for the rear bump stops. Nonetheless, they still rub a little bit on the left side:
I have found that the Curries keep the rig quite level, but believe that this is at the cost of flex.
The squeeking for my setup was mostly due to the sway bar links. A couple of drops of gun oil ("CLP") solved that really well. I have not greased the bushings yet, so still some squeeking left there.
But it is not flush because I believe that ORE did this to make room for the rear bump stops. Nonetheless, they still rub a little bit on the left side:
I have found that the Curries keep the rig quite level, but believe that this is at the cost of flex.
The squeeking for my setup was mostly due to the sway bar links. A couple of drops of gun oil ("CLP") solved that really well. I have not greased the bushings yet, so still some squeeking left there.
TormentedCrawler
New member
I've been running it for a while already and so far so good. Haven't had any issues with squeak
TormentedCrawler
New member
Nevada. Did you run the Currie bracket on top of the fascia
Give it some time and you'll see, or should I say "hear" what I talking about. That being said, I never said that it didn't work, just that it WILL limit your flex when compared to a stock sway bar.
TormentedCrawler
New member
NevadaZielmeister
Caught the Bug
Yes, I already had the fascia and the d-ring shackles installed when I dropped her off. They appear to have simply slapped the Currie bracket on top.
Not the evo facia but i got the same setup
Attachments
NevadaZielmeister
Caught the Bug
I guess you could cut the fascia if you wanted.
TormentedCrawler
New member
If I notch the bumper will 2 bolts on each side be sufficient enough.
NevadaZielmeister
Caught the Bug
On the fascia, I don't see why not?
TormentedCrawler
New member
I would hate to cut it though. I'll see if I can mount the brackets to the outside
All u have to do is cut a 1/4 inch off the currie antirock brackets where the torsion bar slipps thru.
Attachments
TormentedCrawler
New member
so I could gain the extra 1/4" to protrude outwards?
Yes sir ,if u look at the instal instructions it tels u where to cut, if running bumper u have to cut if no bumper no cutting. Hope that helps
TormentedCrawler
New member
Awesome will take a look at it again. Thanks for the help guys
Last edited: