J
JKDream
Guest
Has anyone installed this as of yet? Thoughts?
I know the general consensus on this forum is don't bother, and to save for another axle.
Plans will eventually result in a ProRock, but isn't really needed at this time. The Canadian dollar makes the swap a lot more expensive.
I do have a proper shop jig that can stop the axle from warping from the heat (have straightened my axle with it, confirmed by an alignment that it was indeed straight).
Primary reason vs Artec etc is the differential bridge. Not having to pull the gears and preheat/weld the cast is a big bonus.
I know the general consensus on this forum is don't bother, and to save for another axle.
Plans will eventually result in a ProRock, but isn't really needed at this time. The Canadian dollar makes the swap a lot more expensive.
I do have a proper shop jig that can stop the axle from warping from the heat (have straightened my axle with it, confirmed by an alignment that it was indeed straight).
Primary reason vs Artec etc is the differential bridge. Not having to pull the gears and preheat/weld the cast is a big bonus.
Last edited by a moderator: