Jk door hangers

I'll try to start this lil thread
ok this is what I used
1--- 14 gauge flat steel 26.5x13.5
2--- pieces or 1.25x3/16 flat bar 9 inches long
4---3/4 .120 wall tubing 1.5 long

Drilled 3 holes on each side to mount it to the wall which at the end of it should be 16 inch apart since most walls are built on 16 inch center

After that I layer it out where the. Bends would need to go and then flip it over and mark the other side

And the after u get it broke I'll
Have to check to see what degree I bent them to the way I measured was 32degrees

Next you weld the tubing to the flat bar

Then weld them
To the main piece from I measured 12.25 top to top of the tubing

If this is out of line guys I will delete this but can also do a lil write up on it if you guys would like


Sent from my iPhone using WAYALIFE mobile app

It's a great idea and a write-up would be awesome but unfortunately, your original post does cross the line.

Point taken thank ya


Sent from my iPhone using WAYALIFE mobile app

72dozer said:

Point taken thank ya

Click to expand...

I appreciate your understanding and again, great idea :thumb:

I'd love a write up on this. There's a similar product on the market but I think it's like $150 and I'd love to have a DIY version

°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°°
http://wayalife.com/showthread.php?p=621404