dpetersen1988
Member
Anyone know why my drivers side front axle shaft won't come out, it turns freely and will not come out.
Tried doing that and it's not wanting to budge on the stock shafts are their c clips? From what I know the stock shafts don't have those.
Sent from my SM-G955U using WAYALIFE mobile app
Tried doing that and it's not wanting to budge on the stock shafts are their c clips? From what I know the stock shafts don't have those.
Sent from my SM-G955U using WAYALIFE mobile app
Nothing. As already mentioned, a slide hammer will help. A brass hammer will help. There has been a few post threads with folks having a hard time but they will come out.Is there anything in the carrier that could be locking the stock shaft in I have pulled and pulled and it will not budge
Sent from my SM-G955U using WAYALIFE mobile app
How much time did you spend Yanking on your shaft? Maybe it just needs to be Yanked harder? What about Beating on it first a little.. to loosen it up, then a good Yank....
How much time did you spend Yanking on your shaft? Maybe it just needs to be Yanked harder? What about Beating on it first a little.. to loosen it up, then a good Yank....
If you thought the axle shafts were bad wait until you try the ball joints... Just when you think you're at the point of breaking the press you're about half-way to breaking them loose.Got the bastard those things are in there good a sliding hammer wouldn't even get it, i had to literally go ape shit on it, now time for the ball joints and then my new axle shafts.