Johnny HotFoot
New member
My 2010 Rubi with 111,000 Miles (only 80,000 on trans) runs fine when I leave the overdrive OFF, but if I don’t, the trans ‘slips’ when shifting and at times runs higher revs at high speed and trips error code P1750 and eventually will trip CEL.
P1750 is the fault immediately after shift
I’m hoping to fix this myself - need some help figuring what to fix.
It feels awful. When I let off gas it feels like the brakes were pumped. It slips on shifts yet feels fine when overdrive is turned off at start.
Thanks in advance.
UPDATE: code P 0733 is now Throwing the CHeck Engine Lite. And worse
I now have a clicking sound - my hope is it’s all just a tranny issue but I fear I may have spun a bearing. It sounds bad. .....started it up yesterday and it started making a noise. Loud clunking with the motor movin. Like a do not drive kinda noise.
Thoughts?
Sent from my iPhone using WAYALIFE mobile app
P1750 is the fault immediately after shift
I’m hoping to fix this myself - need some help figuring what to fix.
It feels awful. When I let off gas it feels like the brakes were pumped. It slips on shifts yet feels fine when overdrive is turned off at start.
Thanks in advance.
UPDATE: code P 0733 is now Throwing the CHeck Engine Lite. And worse
I now have a clicking sound - my hope is it’s all just a tranny issue but I fear I may have spun a bearing. It sounds bad. .....started it up yesterday and it started making a noise. Loud clunking with the motor movin. Like a do not drive kinda noise.
Thoughts?
Sent from my iPhone using WAYALIFE mobile app
Last edited:
