Traction control light turned on after psc hydro installed

J

joecoool2003

Member

• Mar 1, 2018

• #1

I just installed my hydro and as soon as i started it up the traction control light turned on, it wasnt on before i installed it.... also its just the traction control light, not the abs light also.....
Steering wheel centered.... dont know what might cause it to turn on? Any ideas are appreciated

 

Mike_JK_Houston_711

New member

• Mar 1, 2018

• #2

Speed sensors good? Clock spring? Your steering wheel could have rotated too much during the install also. You would have to disconnect the shaft and recenter the wheel.


Sent from my iPhone using WAYALIFE mobile app

 

Mike_JK_Houston_711

New member

• Mar 1, 2018

• #3

Inbox is full


Sent from my iPhone using WAYALIFE mobile app

 

J

jsukey

Member

• Mar 2, 2018

• #4

Did you tie your steering wheel down before the install? From what I've read, sounds like it may have rotated on you.

 

J

joecoool2003

Member

• Mar 2, 2018

• #5

jsukey said:

Did you tie your steering wheel down before the install? From what I've read, sounds like it may have rotated on you.

Click to expand...

That's what happened

 

TrainWreck618

Caught the Bug

• Mar 2, 2018

• #6

joecoool2003 said:

That's what happened

Click to expand...

Dang.. best way to make sure that doesn't happen again is to strap the steering wheel to the brake pedal. As far as fixing what you've done, I have no clue. Maybe try adjusting a half turn at a time until the light turns off*


Sent from my iPhone using WAYALIFE mobile app