manufactures of unit bearing

B

Bingobelle

Member
Hi

I just bought a new unit beearing for my jk. On the paper box it says Precision. Can not find much info about them. On the unit bearing itself it has this number: 513272 G3 Fc29

Also it says on the paper box : Replaces FM 51372
SKF BR930612

Are those Precision unit bearing any good or is it chinese crap? How good compared to original unit bearing?

Thanks
 
jeeeep

jeeeep

Hooked
I run precision hubs, I like that they have a 3yr warranty in the US

2010 JKU, pr44 front, stock rear, 37's, hydro assist steering

The Precision held up longer than the Timkins I ran.

I'm guessing they're all pretty much made in China or Mexico
 
jknikos

jknikos

Member
Τimken unit bearings for my d30 are around 200euros here in Greece. I used a cheap Chinese once which I bought 120euros and lasted less than a year.
 
B

Bingobelle

Member
Wonderfull

Took off the old bearing and was going to install the new one. Of course wrong part was shipped. The bearing itself was same but the abs sensor cable was over 30 cm shorter and the rubber connections was not even on the same place. Also the part that is supposed to be attached just in front of the shock was not even there.

No chanche to get it to work. Even with re routing. 30 cm is to much missing.

Had to order original part from dealer instead but about same price anyway. Just a 100 km ride to get them.
 
You must log in or register to reply here.
Top Bottom