aaronstephen
New member
looking for a little advice. I just installed a 2.5" RC BB this past weekend and after I installed the front spacer I noticed the Jeep was LEVEL! I was kinda confused as to why this was. I know it had a rake look and I did install an aftermarket bumper but I didn't think the front was that much lower. So u installed a 1/2 inch spacer in the back just for a little more clearance but that was it since I didn't want that obnoxious rake look again.
So here's my question...
I was thinking I would just return the Rough Country lift all together. I am ordering some Rancho 9000's and was thinking of ordering some 3" EVO Plush Ride Lift Coils. Because I have a 2012 I will be replacing my front drive shaft and I have already installed a rear track bar relocation bracket and extended rear sway bar links. What else would I need to do to make this lift work? I'm trying not to break the bank but I also want to do this right.
Your advice is much appreciated. :thinking:
So here's my question...
I was thinking I would just return the Rough Country lift all together. I am ordering some Rancho 9000's and was thinking of ordering some 3" EVO Plush Ride Lift Coils. Because I have a 2012 I will be replacing my front drive shaft and I have already installed a rear track bar relocation bracket and extended rear sway bar links. What else would I need to do to make this lift work? I'm trying not to break the bank but I also want to do this right.
Your advice is much appreciated. :thinking:
