SteerSmarts tierod

T

TxCoastie

Member
Hey guys/gals. Looking for a lil help here.

After we installed the new tierod things looked good but of course the steering wheel was a bit off.

I get free alignments so I took it in to the shop and had it on the rack the next after we installed it.

After they finished everything was alignment well.

My issue is the drivers side tierod bushing and angle of the tierod. The pasengers side bushing and rod looks level while the drivers side is not level and the bushing is not level either.

Should I be concerned? Doesnt look right.
 

Attachments

  • 15509638466339102701958559016919.jpg
    15509638466339102701958559016919.jpg
    67.3 KB · Views: 260
  • 15509639272825182526729501961344.jpg
    15509639272825182526729501961344.jpg
    80.2 KB · Views: 271
  • 15509639857887617534114609334422.jpg
    15509639857887617534114609334422.jpg
    89.9 KB · Views: 273
jeeeep

jeeeep

Hooked
TxCoastie said:
Hey guys/gals. Looking for a lil help here.

After we installed the new tierod things looked good but of course the steering wheel was a bit off.

I get free alignments so I took it in to the shop and had it on the rack the next after we installed it.

After they finished everything was alignment well.

My issue is the drivers side tierod bushing and angle of the tierod. The pasengers side bushing and rod looks level while the drivers side is not level and the bushing is not level either.

Should I be concerned? Doesnt look right.
Click to expand...

they should both be flat. you'll want to loosen both ends and rotate the ends until they are both flat.

And from experience... steersmarts does not stand behind their product and replacement parts are too expensive.

when it's time to replace a part on those - take a look at Currie instead
 
Turbo21

Turbo21

New member
WJCO said:
Steer Smarts can suck a big fat dick. Fuck those guys. Posers.
Click to expand...

What’s up with them ? Would like to know the backstory for you to get that passionate about them and hear the reason to stay away


Sent from my iPhone using Tapatalk
 
jdofmemi

jdofmemi

Active Member
I'm currently experiencing the other problem with Steer Smart.

I have their tie rod on my Jeep. I didn't buy it, it was on the Jeep when I bought it.
For nearly a year I have been happy with it, and have given it a ton of abuse.

Now one of the tie rod ends is loose. Guess what? No cheap fix like many others, it is a proprietary part, non rebuildable, and only available through them, and nearly $200 for ONE end 🤯🤯🤯

I figure if one is bad, usually the other one is close behind it.

For less $$ than two ends, I'm getting the one Bubba is building at Exodus, and when an end goes bad, it is a cheap and readily available fix.
 
critter812

critter812

New member
When your ready i would get the one from Bubba at Exodus Jeeps his Aluminum TieRod is beefy and can take a hit without bending!
tie.jpg
 
T

TxCoastie

Member
Gotta everything straighten out. Hope it lasts. Apprceciate the help.

I wish I could of known Bubba before I bought the SS setup. When my SS tie rod is done Ill be replacing that with Exodus' aluminum tie rod.

I just saw that link regarding SS being banned from Wayalife. I couldnt read it all but now I see why Eddie and other forum members have a bad taste in the mouths for SS's business practices.

Thanks again for all your help. This forum has been great!
 
You must log in or register to reply here.
Top Bottom