Rock Krawler HD tie rod alignment issues

Hilop

Caught the Bug
Hello Fellas, I currently am running the older RK HD tie rod and can’t seem to get the 1/16-1/8” toe in. Every time I adjust either end one revolution it seems the tie rod won’t go less than a 1/4”. I’ve always done my own alignments and have never had an issue but I just can’t get this on right. Any suggestions would be appreciated.

Thanks
 

wjtstudios

Hooked
I’m not familiar with the RK tie but won’t it allow you to do a half or less revolution to get it dialed exactly in? I know my Fusions operate that way


2015 JKUR AEV JK350
1985 CJ8 Scrambler
 

Hilop

Caught the Bug
I’m not familiar with the RK tie but won’t it allow you to do a half or less revolution to get it dialed exactly in? I know my Fusions operate that way


2015 JKUR AEV JK350
1985 CJ8 Scrambler

No, it’s the older cromoly TR that is has to be as level as possible so I have to do full revolutions. I know Eddie used to run one and has a write up but doesn’t address my issue.
Thanks
 
Top Bottom