Recent content by Jackal01

..........

Like Benito said some have it lowered. Mine is just barely off the dash. I also didn't like the initial height so I painstakingly lowered it.

I have had nothing but good luck with this one. Bought it several years ago from my local store. It's good for the occasional use but I'd buy something else for regular use.

Wife's Recon.

..........

Put in a new dual dash cam by Rexing. Both are HD. So far so good. I don't have a RVM so having the ability to have the rear camera on all the time or as needed is a huge plus. Only issue I have with the system is the USB cable for the rear camera. As seen the connections go straight out. 90...

Installed mine last week! Alignment isn't entirely right so I still have to install a pair of new buckets.

Check out this steaming pile of pig shit. And don't forget Wonder Woman's tiara!

My OEM pump began to fail, at 88k miles, so I replaced it with PSC along with their reservoir. So far it has worked flawlessly with the Redneck Ram (ram and gearbox).

I wired mine into a spod. Not much else to it. I'm not running air lockers so it's just for airing up. The steel braided line has a quick connect female in the grille so I can air up without unlocking and opening the hood.

I'll second the motion on WFO. My tie rod is actually the one from Exodus Jeep's rig when I bought his axles. I like that it doesn't wobble. I sold my synergy tie rod when I got this one. The clamp is fantastic as well. OEM drag link.

SOLD Pre-Rigid Industries model. Bought in summer 2013. No issues. Come with the harnesses. $200 plus shipping. No trades. High and low beams on.

The food was delicious.

The pics should show it well enough but this onr may help. They go down from the box, under the track bar, then between the tie rod and track bar.

I see where my confusion came from. My first set of hoses were like yours with separate 90s. I got a second set from them that they installed when I ran into an issue however I didn't pay attention to the difference until this thread. I bent one this weekend out wheeling and ordered a new...