Thanks for the reply! Sounds like I have more measuring and cycling to do to really dial things in. I’ll likely start over from what my factory arms were and add incrementally from there until I get things set to a more realistic place.
My biggest question is: how do I ensure my axle is centered in the wheel well? When I installed the control arms, I set them to factory length plus .5” and they were not even close. Most lift kits seem to indicate that to be the correct length (give or take a half an inch), which makes me...
Reviving this thread as I am installing suspension and I’m just about to the point of dialing in control arm length/alignment.
I’m installing 3.5” Rockkrawler springs with correction pads in the rear. Fox coilovers in the front with air bumps aiming for 4.5” lift. Metalcloak control arms all...