Recent content by Jeepfan30

While my front driveshaft was off getting balanced I noticed that when I hit the front TC yoke with the palm of my hand in an upward motion there is some play. No play in and out, just up and down when tapping up on it. Nut is torqued to 160 ft/lbs and it’s the yoke that came with my Adams 1310...

Full Metal Fabworks Apex Pinnacle stubby front bumper. I mounted it up for one day, but couldn't part with my EVO quarter pounder. Bumper has recessed winch mount, fog light buckets, bull bar and shackle tabs. Paid $615 for bumper, and $180 for powder coating. Willing to sell for $625. I am not...

Just found this winch guard online, looks like it will bolt on to the EVO 1/4 pounder to me. Anybody think otherwise? Thanks

Tire wear look ok? They are due for a rotation.

I recently replaced my tie rod and drag link, did the home alignment posted here and toe is currently set 1/16 in. The problem is, when my wheel is straight the front passenger front tire appears to point out a bit, while the driver front tire appears to be straight. Should I adjust the tie rod...

Some pics of Mt Rainier from last weekend.

Love taking the doors off.

Adams front driveshaft.

Those are super short. Mine look like this. I have the EVO drag link flip, but use the stock sway bar link mounting points.

Ten Factory rear axle shafts to replace my bent flange :thumb:

Washington State, Rattlesnake Ledge.

I replaced all the u-joints and centering ball yoke in my front JE Reel 1310 driveshaft last week. Should I get it re-balanced? I remember reading that if it's not put back together the same way it came apart it my be out of balance. Thanks,

How much play should there be in the h block u-joints on a front DS? I have a JE Reel with greasable u-joints, about 35k miles on it. When I grab the h block I can wiggle it back and forth, decent amount of play. Time for new u-joints? Thanks,

Tahuya ORV, WA

Here's a pic of 1/4 without stinger. Nice and clean :thumb: