Recent content by theprez

Hey All - So I did some additional suspension work (front upper and lower adjustable control arms, front and rear adjustable trackbar) and needed to get the vehicle aligned - also wanted to check my own DIY alignment work for piece of mind. My JK has stock drive shafts and a Teraflex 2.5 inch...

Out of curiosity I decided to see what it was currently...88.7 - close enough id imagine :)

Hey All- Although I just recently had my JK aligned professionally, upon reading this link it seems fairly simple: http://wayalife.com/showthread.php?3861-Basic-Do-it-Yourself-Jeep-JK-Wrangler-Front-End-Alignment One question I had was on taking the caster measurements - either on top of the...

After installing lower control arms I had my jeep aligned this morning but not quite sure what I'm looking at - are these good numbers? Thanks

Hey All - I'm going to be installing my adjustable LCA this weekend...and as a result, removing the cambolts. I purchased a Synergy Cam Bolt Eliminator kit - basically 2 washers that fit in the mounts on each side. Is the stock control arm bolt long enough to accommodate the width of these...

Hi All - New to the board but it's been a great help already with my 2014 Anvil JKU. Let the modding begin! =)

Hey All - First time poster and long time lurker :) My 2014 JKU was lifted about 6 months ago - it's the 2.5 inch Teraflex lift. After install, the Jeep would "wander" all over the road - took it in for an alignment and they used "cam bolts" to get the Jeep closer in spec. It was much better...