Search:

Type: Posts; User: mayday_soc

Search: Search took 0.06 seconds.

  1. Poll: How much shock shaft do you guys recommend to...

    How much shock shaft do you guys recommend to have showing front and rear? Also, how does shock shaft equate to uptravel in the rear seeing that the coilovers are angled back? Would 3.5Ē of shock...
  2. Thread: Heim vs TRE

    by mayday_soc
    Replies
    0
    Views
    160

    Heim vs TRE

    What are the benefits (and negatives) when switching to a heim joint steering setup? Most of the research I’ve done compares them to Johnny joints relating to control arms. I’m only concerned with...
  3. Or we could send a well written letter to Evo to...

    Or we could send a well written letter to Evo to make just a few more aluminum 1/4 pounders. Just a few more.
  4. Thread: Greasing

    by mayday_soc
    Replies
    12
    Views
    1,252

    Iím going to try and loosen the few zerks Iím...

    Iím going to try and loosen the few zerks Iím having problems with. Sounds like thatís my problem.




    Whoa... Thank you for the link. Looks like Iíll be drilling some holes next weekend.
  5. Thread: Greasing

    by mayday_soc
    Replies
    12
    Views
    1,252

    I was wondering the same thing about Johnny...

    I was wondering the same thing about Johnny joints. Some joints fight the grease gun and wonít take any grease. Others take plenty and it oozes out and I wonder if thatís good or bad. And other...
  6. Whoa! Thanks for timing it. Iím going to have to...

    Whoa! Thanks for timing it. Iím going to have to investigate mine further. Iím going to try dipping a paint brush in the soapy water and hitting all the seams.
  7. Thatís how my compressor works ...but every 1:50...

    Thatís how my compressor works ...but every 1:50 it kicks back on for a second. Even if I just fill the manifold and and donít use any accessories like lockers, swaybar, etc. Iíve gotta have a leak...
  8. I have NOT checked the black end caps. Damn, I...

    I have NOT checked the black end caps. Damn, I def have a leak from what you guys are saying.
  9. Replies
    16
    Views
    977

    I had planned on powder coating the aluminum.

    I had planned on powder coating the aluminum.
  10. How long till your ARB compressor kicks on?

    Iím not trying to start a competition or anything. Iím just looking for what would be considered a reasonable amount of time before the arb compressor kicks on to recharge the air manifold after itís...
  11. Replies
    16
    Views
    977

    That was my reason for wanting aluminum. The...

    That was my reason for wanting aluminum. The weight savings is just a bonus to me.
  12. Replies
    16
    Views
    977

    Also not the news I was looking for. Why do you...

    Also not the news I was looking for. Why do you think they stopped making them, lack of sales?
  13. Replies
    16
    Views
    977

    Not the news I was looking for. Thank you for...

    Not the news I was looking for. Thank you for letting me know. I guess Iíll just scour the Internet for used ones :(
  14. Replies
    16
    Views
    977

    Evo aluminum 1/4 pounder

    Looks like theyíve been recently discontinued. Any recommended vendors of this site that may stock them?
  15. Replies
    140
    Views
    9,930

    Iím curious to the dyno print out as well. Why...

    Iím curious to the dyno print out as well. Why type of dyno? What gear did you do the pulls in? I still have my dyno print out. AWD Mustang dyno. Couldnít do the rear wheel dyno because the Jeep kept...
  16. Replies
    140
    Views
    9,930

    Iím glad you like your SC. My experience has been...

    Iím glad you like your SC. My experience has been a little bit different. I have the sprintex stage II (SPS) kit. The tune from sprintex was less than useless. The drive-ability was awful. It...
  17. Replies
    9
    Views
    677

    Iíll buy those horns off you. The rears too if...

    Iíll buy those horns off you. The rears too if youíre cutting them.
  18. Thread: EVOlever

    by mayday_soc
    Replies
    3
    Views
    300

    EVOlever

    Only an idiot would chop their rear frame... But letís just say they did. Whatís the best way to repair it to install the EVOlever system? Chop one off another Jeep? Get the Genright repair kit? etc....
  19. Replies
    14
    Views
    528

    Belated wave from RI

    So I joined the forum the end of Ď16 when I bought my first Jeep but never post much and never gave a proper wave. I do a lot of lurking on this forum. Itís my go to for research and the only forum I...
  20. Replies
    425
    Views
    80,935

    Installing a roof mount CB this weekend. Planned...

    Installing a roof mount CB this weekend. Planned on running a ground strap from the carrier to the tub. Are most people using one of the high mount holes (if not running a high mount) to bond the...
  21. Replies
    13
    Views
    1,331

    I went into my local audio store and I was set on...

    I went into my local audio store and I was set on Viper. They recommended Compustar (they're an AD for both). I've been really happy with it. I have gps tracking, tilt sensor, impact sensors,...
  22. Replies
    12
    Views
    1,413

    Thank you for the responses. Cozdude, there...

    Thank you for the responses.

    Cozdude, there was a thread on here while I was researching the No limit. Several members had to either cut a coil off their spring or use a thinner washer. The knob...
  23. Replies
    12
    Views
    1,413

    No imits question

    Hello everyone, new member.
    Searched the forum as to not waste anyone's time but is the AEV Procal the only way to turn off the sway bar light when using the No Limits? I'd much rather run the...
Results 1 to 23 of 23
About us
ďwayoflifeĒ is a moniker that Iíve been using for 20 years now and I chose it because I think it does a great job of explaining, in simple terms, the passion I have for Jeeps and the Jeep way of life. This is a lifestyle that transcends age, gender and race as the only thing you need to be a part of it is a love for the outdoors, a desire to explore, a yearning to take on a challenge and a will to conquer it. Over the years, Cindy and I have attempted to capture the essence of this lifestyle through photographs and videos and share it with others around the world. And, this is how WAYALIFE was born.
Join us
WATCH OUR VIDEOS