Search:

Type: Posts; User: desertrunner

Page 1 of 20 1 2 3 4

Search: Search took 0.04 seconds.

  1. Replies
    11
    Views
    260

    In what manner did it break? Twisted spline...

    In what manner did it break? Twisted spline snapped in by the carrier?
    Snap by the flange?

    Sent from my SM-G950U using WAYALIFE mobile app
  2. Replies
    602
    Views
    37,277

    Well I do need to update 1 thing on this I...

    Well I do need to update 1 thing on this
    I don't think that occupancy sensor is picking up any weight. I had my wife take off her seat belt while driving and it never registered or dinged at us so...
  3. Replies
    121
    Views
    4,969

    I definitely understand that it's stronger than...

    I definitely understand that it's stronger than the traditional SF60 but if you need the strength of a FF axle in the rear doesnt that mean you need it in the front too? Seems like an odd thing to...
  4. Replies
    172
    Views
    11,372

    Can't speak for strength but I can speak to...

    Can't speak for strength but I can speak to flexibility. I drug mine over a rock and it deformed like crazy and came back straight and have personally seen stock ones be bent from the amount of...
  5. Replies
    602
    Views
    37,277

    Thanks gents. I really like the way they look. I...

    Thanks gents. I really like the way they look. I think they need to break in a bit because I wouldn't quite call them comfortable just yet. But the Tweed fabric is pretty tight and stiff so I think...
  6. Replies
    602
    Views
    37,277

    I know I know I have been busy with work and...

    I know I know I have been busy with work and kinda did over 3k worth of damage to my truck right after I finished the drivers seat so....
    Did you get yours worked out with no dash lights?

    Sent...
  7. Replies
    602
    Views
    37,277

    Ok finally got the passenger seat wrapped up and...

    Ok finally got the passenger seat wrapped up and fully installed. Made a very similar bracket for the passenger side that I did for the drivers side. It's a little longer and at a different angle to...
  8. Replies
    26
    Views
    1,167

    If the compressor is cycling on and off there is...

    If the compressor is cycling on and off there is definitely a leak somewhere. I had that with my ARBs in 2 different spots. The bulkhead on the front diff and a connection between by compressor line...
  9. Replies
    31
    Views
    910

    Nice! Definitely on my to buy list Sent from...

    Nice! Definitely on my to buy list

    Sent from my SM-G950U using WAYALIFE mobile app
  10. Replies
    31
    Views
    910

    What did you plug that with? Sent from my...

    What did you plug that with?

    Sent from my SM-G950U using WAYALIFE mobile app
  11. Replies
    602
    Views
    37,277

    I'm sure some day I'll look back and laugh but...

    I'm sure some day I'll look back and laugh but right now I feel pretty fucking stupid. I just completely didn't see it as it was just below hood height and I was gassing around the turn. Totally...
  12. Replies
    602
    Views
    37,277

    Well it's a good thing I at least got the drivers...

    Well it's a good thing I at least got the drivers seat done because that same night my dumb ass smoked a concrete pole in a parking lot in my truck head on. Damage from the outside doesn't look...
  13. Replies
    18
    Views
    325

    Welcome! My in laws have a house up in Hailey....

    Welcome!
    My in laws have a house up in Hailey. Definitely a beautiful area

    Sent from my SM-G950U using WAYALIFE mobile app
  14. Replies
    602
    Views
    37,277

    So I was able to cut the heads off of those...

    So I was able to cut the heads off of those rivets and pull that bar off pretty easy. That bar was only there to allow the slide to move freely when the seat is folded forward so really no impact to...
  15. Replies
    602
    Views
    37,277

    So this is the occupancy weight sensor in the...

    So this is the occupancy weight sensor in the passenger seat. The spot in the middle where the part number sticker is is where it is glued to the foam. This seat was already pretty F'ed up so I...
  16. Replies
    602
    Views
    37,277

    Ran into my first snag on the passenger side. So...

    Ran into my first snag on the passenger side. So the stock slider mount on the passenger side has some lateral bar support that was not on the drivers side. The PRP mount is supposed to sit flush to...
  17. Replies
    602
    Views
    37,277

    Got the drivers side all finished up. Everything...

    Got the drivers side all finished up. Everything is bolted down and fits nicely. The buckle extension worked out and got all nylock nuts installed with it and I still have full range of the slide...
  18. Replies
    602
    Views
    37,277

    Gotta clean it up so make it less sharp and get...

    Gotta clean it up so make it less sharp and get some longer bolts for the attachments but I think my bar steel extension is going to work out well. 337388337389337390337391

    Sent from my SM-G950U...
  19. Replies
    12
    Views
    787

    I second the motion for 4.88s sounds like they...

    I second the motion for 4.88s sounds like they would be a good fit. For just 35s and light wheeling I think new axles would be over kill. If you want to add a locker, during the re gear is a perfect...
  20. Replies
    602
    Views
    37,277

    I mean in the 3 years I have owned the jeep the...

    I mean in the 3 years I have owned the jeep the back seats have been removed since day 1 and I have only reached in through the front to grab a water bottle or something maybe a handfull of times...
  21. Replies
    602
    Views
    37,277

    I saw in a YouTube video a guy who pulled that...

    I saw in a YouTube video a guy who pulled that sensor out of the stock seat, Took some work to do and you have to be gentle not to break it, Then stuffed it in the PRP seat in the 5th point slot....
  22. Replies
    602
    Views
    37,277

    For reference this is what it looks like with the...

    For reference this is what it looks like with the seat all the way forward and tumbled.
    It's a tight fit but I was able to squeeze myself into the back. But at 5'9" 160 I'm not a large person so it...
  23. Replies
    602
    Views
    37,277

    So plan of attack right now for the drivers side...

    So plan of attack right now for the drivers side buckle. I plan to attach it to the back right corner seat mount. With it attached at that point right now the buckle is pretty buried but I can still...
  24. Replies
    602
    Views
    37,277

    Did you put the weight sensor from the stock...

    Did you put the weight sensor from the stock passenger seat into the new seat?

    Sent from my SM-G950U using WAYALIFE mobile app
  25. Replies
    602
    Views
    37,277

    Nope it's fixed back. But sliding it all the way...

    Nope it's fixed back. But sliding it all the way forward and tumbling it a child could still squeeze in the back if they need to and I can reach gear behind the seat. It's a right fit but it's better...
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
About us
“wayoflife” is a moniker that I’ve been using for 20 years now and I chose it because I think it does a great job of explaining, in simple terms, the passion I have for Jeeps and the Jeep way of life. This is a lifestyle that transcends age, gender and race as the only thing you need to be a part of it is a love for the outdoors, a desire to explore, a yearning to take on a challenge and a will to conquer it. Over the years, Cindy and I have attempted to capture the essence of this lifestyle through photographs and videos and share it with others around the world. And, this is how WAYALIFE was born.
Join us
WATCH OUR VIDEOS