Search:

Type: Posts; User: PT1400

Page 1 of 7 1 2 3 4

Search: Search took 0.05 seconds.

  1. Replies
    5
    Views
    772

    Send it back. They shipped you the wrong one.

    Send it back. They shipped you the wrong one.
  2. Replies
    9
    Views
    1,523

    Oooo, pump might have burned up if it had a...

    Oooo, pump might have burned up if it had a plugged strainer. Do the testing in that video!
  3. Replies
    2
    Views
    442

    Get a shop manual if you don't have one. ...

    Get a shop manual if you don't have one. Chilton's, Hanson's, etc.

    Disconnect the battery and disconnect the connections of the pcm(right be hind the battery. Check for dirt, water, corrosion,...
  4. Replies
    9
    Views
    1,523

    Either the regulator is bad, you could have a...

    Either the regulator is bad, you could have a leak, or the electric pump in the tank is having an issue.

    Check out this video. He's a little rough around the edges but explains what he's doing...
  5. Replies
    9
    Views
    1,523

    What snboadr said. The fuel prime cycle is up to...

    What snboadr said. The fuel prime cycle is up to 10 seconds per key cycle or until the fuel pressure reaches 40 psi. If it takes more than 1 cycle to prime the system you need to have the regulator...
  6. There is not an EGR System on either engine...

    There is not an EGR System on either engine option.
  7. Is it still in place? Did it get put in...

    Is it still in place? Did it get put in backwards and the metal teeth chew up the plastic ones?
  8. Thread: Over heating

    by PT1400
    Replies
    11
    Views
    1,043

    A pusher fan? Those are for under 15 mph on...

    A pusher fan? Those are for under 15 mph on equipment.

    How many blades does your fan have currently? Electric or hydraulic? Is it a glade blade or curved?

    The reason I ask is that you...
  9. Thread: Question

    by PT1400
    Replies
    7
    Views
    562

    Honestly, for me, regearing is where I'd start. ...

    Honestly, for me, regearing is where I'd start. Unless you're building a prerunner or a highway king, gearing will give you more where it counts. Regearing will also be easier on the engine, trans,...
  10. Replies
    9
    Views
    1,101

    This isn't very clear. Is the starter actually...

    This isn't very clear. Is the starter actually turning the engine? Or is it engaging and not turning the engine?
  11. Thread: Over heating

    by PT1400
    Replies
    11
    Views
    1,043

    Is the radiator loosing coolant out the cap? ...

    Is the radiator loosing coolant out the cap? While running or after shutdown?

    Do you have a temp gun of some sort to confirm it's not a bad temp sender/sensor? If so, what are the temps at...
  12. Thread: Over heating

    by PT1400
    Replies
    11
    Views
    1,043

    Oh wait. Having too lean a air/fuel mix or...

    Oh wait. Having too lean a air/fuel mix or timing will also cause an overheating issue! And you've got a carb.
  13. Thread: Over heating

    by PT1400
    Replies
    11
    Views
    1,043

    I'm guessing: lift and bigger tires. What rpm...

    I'm guessing: lift and bigger tires. What rpm range are you at when you are at 55? Having a 3 SPD with a granny might have something to do with it. Having the revs at 3000+ rpm at 55 will do it.
  14. Thread: Over heating

    by PT1400
    Replies
    11
    Views
    1,043

    What is your radiator cap rated at? Did you...

    What is your radiator cap rated at? Did you reuse the old cap when you swapped the radiator? Do you have an IR temp gun?
  15. Replies
    3
    Views
    482

    You probably don't want to hear this. Take the...

    You probably don't want to hear this. Take the pcm to the local dealer. The new pcm will have to be programmed either way. They should have a breakout harness to connect to it, to do the...
  16. Good to hear!! I'm sure the rubber in them was...

    Good to hear!! I'm sure the rubber in them was toast.
  17. Replies
    9
    Views
    1,169

    You said you had plenty of volts but what were...

    You said you had plenty of volts but what were the volts while cranking? The PCM shuts down below 9.6 volts.
  18. Replies
    5
    Views
    648

    Get yourself a service manual like Haynes or...

    Get yourself a service manual like Haynes or Chilton's. There will be a Fuel System section with fuel pressure specs that can be checked with a cheap pressure gauge. Start there and spark plugs. ...
  19. Replies
    2
    Views
    600

    Start with a basic search on the Google or get...

    Start with a basic search on the Google or get yourself a Service Manual. You're going to need it anyway and they're like $35. Might not Bevan easy fix. All of this was found in less than 1...
  20. Looks right. As long as you tube is between...

    Looks right. As long as you tube is between 3-3.5", you're good.
  21. That's the rear track bar mount, axle side,with...

    That's the rear track bar mount, axle side,with the extension on it. The extension is for when the jeep is lifted and keeps the axle pointing in the right direction.

    Look up your year and model...
  22. Thread: Antenna??

    by PT1400
    Replies
    5
    Views
    538

    Do you have a stock or aftermarket stereo? Mos...

    Do you have a stock or aftermarket stereo? Mos of the time the aftermarket stereos have the antenna connection opposite of the stock stereo. I had the same issue with the new stereo, put a 1'...
  23. Replies
    26
    Views
    4,640

    Another thing you could do is a little math. ...

    Another thing you could do is a little math.

    Tire weight rating X 4 tires. Say it's weight rating is 2250 lbs per tire.
    2250 X 4=9000 lbs

    Weight of your jeep ÷ 9000
    Say you Jeep weighs in at...
  24. Replies
    2
    Views
    321

    Never heard of them. Nothing wrong with a reman...

    Never heard of them. Nothing wrong with a reman in my opinion.
  25. Replies
    26
    Views
    4,640

    Add weight. Seriously. Add enough weight to...

    Add weight. Seriously. Add enough weight to drop the fender height a half inch. Also if your air pressure is over 25 psi, you're killing yourself.
Results 1 to 25 of 159
Page 1 of 7 1 2 3 4
About us
“wayoflife” is a moniker that I’ve been using for 20 years now and I chose it because I think it does a great job of explaining, in simple terms, the passion I have for Jeeps and the Jeep way of life. This is a lifestyle that transcends age, gender and race as the only thing you need to be a part of it is a love for the outdoors, a desire to explore, a yearning to take on a challenge and a will to conquer it. Over the years, Cindy and I have attempted to capture the essence of this lifestyle through photographs and videos and share it with others around the world. And, this is how WAYALIFE was born.
Join us
WATCH OUR VIDEOS