Search results

I got my new axles swapped in and a tierod flip kit installed. My Adjustable track bar won't go to stock length. So I need one that will work. Just need to get back on the road.

any updates?

JKU on 37s with 4.88s Avg 15mpg mixed

Ratchet straps are your best friend. But not all is well. Went to grab the step to slide in place and it seems Motobilt sent me to driver side steps. Sucks...well crap just noticed I have 2 passenger side uppers aswell. Found out through Motobilt, that Northridge4x4 is pulling the wrong parts...

Swapped Radiators. Got rid of the junky Mishimoto one for an OEM Replacement. Pic of the Rockers painted. Cut the Tierod Bung off and ordered a new one. Should be here Tuesday. Spent a good hr cutting and grinding to get the extra plate of steel welded to my factory track bar mount off.

Thanks everyone

2011 JKU I'm swapping in a new set of Axles, but waiting on some more parts for the front end. Going from 4.88 to 5.38 gears. The Rear axle is ready to swap out. Would I run into any issues just swapping the rear axle, if I pull the front drive shaft? And just swap the front out later...

Got my Motobilt Rockers painted and ready to install. Tried to get my Tierod finished today. Welded the Bungs on and one warped on me. So I've got to cut it off and already ordered another.

Shafts installed. Had to make some adjustments to make everything clear. While I was working on my axles UPS dropped off my Motobilt Rockers.

Thanks

NO BODY - Great movie, one of the better ones I've watched lately Mortal Kombat - Boring, all the good scenes are in the commercials.

lol, Sorry should have been more clear. Looking for the Harness plug for the locker.

Looking for 2x UD44 Plugs for Rubicon Axles

I ran into a small clearance issue. They said it happens with about 5% of the JKs. I've got to shave a little from my Outer yoke and a little from the lower nut. Not a huge deal Went to bolt on my Front Track bar mount. ran into an issue there too. The last owner reinforced it by adding a...

I think you'll like them.

Not bad, tops where super tight. Used a Press on those. Other then that install was smooth.

display resolution wxga

Getting more work done. Getting very close to getting these under the Jeep Now...Just 2 more coats of black on the axles and I'm ready to install my Knuckles, Bearings and Brakes over.