Search results

Overall length from splines to threads is about 26.25" Splines to the bottom of the ¿UJoint ears? Is about 17.5"

So I got bored this evening and wanted to make sure all the parts I have ordered would fit together when I ran into this: I don't know what this should look like inside but this is what I have with the knuckles, unit bearings and axle shafts installed. Could anyone tell me if this is right or...

a friend of mine ran 35s with no lift, he just cut his pinch seems and refused to cut his factory fenders. it worked for a while, he now has a 4" lift. i would trim the fenders, where ever else necessary to prevent rubbing and 2" bumpstops in the rear, this is how i ran 37s for a couple of...

So I got my bump stop issue resolve. I took the 4" aluminum synergy bump stops to a friends machine shop and shortened them to 3.5" and bore out the hole for a .5" bolt and bore out the top to have the cap head counter sunk. Then I went to the hardware store and found the bolts. Total cost $1...

Pr 44 I finally received my PR44 from Trail Jeeps!! can't wait to get it installed! My living room is starting to fell cramped! i will probably post this question on another relevant thread, but what is everybody using for bumpstops on the PR44? i had bought some 4" synergy bumpstops to...

I got it in through the hole that is used for the window wash line for rear window. I had to modify the gasket a little

Received my JE Reel 1350 rear drive shaft today Adding it to my parts pile I also received my new unit bearings, I figured since I was replacing the housing and ball joints I would go ahead and get new bearings as well!

this is what you have...

I am starting to beef up my jeep and am currently waiting on some parts to come in in preparation for a trip to the rubicon hopefully this year with my dad, a sport cage would be a great addition to the build sheet!

"....keep the shiny side up, at least 2 on the floor..." -renegade version. that little jeep is pretty darn cool.

vote for #4

Steer Smarts Yeti Tie Rod just received my steer smarts yeti tie rod, this thing is massive. i think it will hold upto to PSC kit. Parts are starting to accumulate again!

The exhaust loop on the drivers side

Got around to installing my Switch Pro this morning, install went smooth and easy. I will say that the instructions are very easy to follow and not confusing at all! I even rerouted my winch wiring. As you can see the mosfet unit takes up very little space I routed the wires that go into...

Shouldn't be to hard.

I did that! Trim your fenders- flat fender mod, trim your front and rear pinch seams about 1.5"-2", install 2" bump stop extensions in the rear, rear out steering stops about 1/4", stubby your front bumper and trim the rear bumper or remove all together. Probably could have used a 1" bump stop...

Yup, I had to grind the top outer edges of the frame horns so that the top front bolt on the stinger plate could be used

The guy that started crawler conceptz was the lead designer for poison spider is what I heard* *read

Time for an update. Since post #47 I re-sprayed the cut fenders with bed liner, I broke some of the clips and bought some off of amazon. The front passenger side fender only had Amazon fender clips and flew away on the highway, thankfully it didn't hit anybody, I turned around to pick it up but...

Boom