Painted bumpers, sliders and installed full set of Currie Control Arms.
Those wheels look good!
Sent from my iPhone using WAYALIFE mobile app
Matthew Nicholas
The Wampa- 16’ JK Rubicon Hard Rock
Jeep parts and accessories purchased through the RECOMMENDED-Jeep-Parts-amp-Accessories section of this forum will help support this forum and at no cost to you.
Painted bumpers, sliders and installed full set of Currie Control Arms.
Got my new sliders welded on and painted up.
slid.jpg
IMG_3674.jpgIMG_3684.jpgIMG_3670.jpg
Sent from my iPhone using WAYALIFE mobile app
New shoes for the JL! IMG_0225.jpgIMG_0320.jpg
I did really like the look of the factory wheels but the width & offset wasn’t ideal for the tires I’m running now. Actually discount tire wouldn’t even balance them for me with the factory wheels on the 37’s. Really don’t see how that makes them liable but anyway, not an issue anymore!
Image1552622569.771095.jpg
Finally fitted my new wheels with 305/70R17 Maxxis Razr
Sent from my iPhone using WAYALIFE mobile app
I see this was a popular mod recently. While on R&R had my sliders and C-gussets burned on, Mounted up my new 37" Coopers to my new Machetes (no balance needed) Also loving the fact that my RPM's dropped down to 2300 @ 75mph from 2900 rpm's. and trimmed the pinch seam. Dropped off the new Nemesis Notorious fenders for paint match. A shout out to Zan and ORE for making a little mistake right again. When I arrived home for R&R was going to stop by ORE and pick up my new wheels on the way home. Mistakenly my wheels had been mounted on another customers tires. Zan had my wheels delivered to my door the very next day (Saturday) before 2pm. Thanks again Zan and Off Road Evolution.20190208_232459.jpg20190213_135259.jpg20190213_135306.jpg
Is that gonna rub? I had to do a lot of inner fender trimming on 3” plush coils
Sent from my iPhone using WAYALIFE mobile app
Oh Yea it rubs... Did a little off road testing found the rear wanted to rub more than the front. Installing the Nemesis fenders next trip home their at paint shop now. Ran out of time. I have a 4" ProComp lift now which measures about 3.5 lift. Next will be either front axle or bolt-on coilovers probably both at the same time. Did you have to have your wheels and tires balanced?