thechrisjones
New member
So I got the 2 1/2 inch LED lights from PSC but I'm not sure what to do to keep them in place . Help anyone?
How to get the 2 1/2 inch led lights to fit the brawler II bumper pre-cut holes?
- Thread starter thechrisjones
- Start date
toxicwaste29
New member
They should need rubber grommets. This is just the first link I found; you can get them elsewhere.
http://www.tankerpartsstore.com/mm5...roduct_Code=TRU-10702&Category_Code=TRUMARKER
http://www.tankerpartsstore.com/mm5...roduct_Code=TRU-10702&Category_Code=TRUMARKER
thechrisjones
New member
They came with these but they don't fit tight at all!
SaddleTramp
Member
Call Rick at PSC. They've always been super helpful when I've called them. The rear lights are just held in by the rubber grommet, maybe you ended up with the wrong size? PSC's staff may be all out at KOH this week but I'm sure they can sort it out for ya.
BigPrince
New member
Just in case, I didn't think they really fit when I got them as well. To me they were a little counter intuitive. Put the grommets in from the front around the inner lip, run the wire and connect the light from the back to the front and then push the light in from the front until the grommet sucks into the back and just the front part is over the front of the inner lip of the fender. It feels like they could fall out if you push them all the way through or out the front but they won't go anywhere.